HAITIAN MA900 II eco

HAITIAN MA900 II eco

This HAITIAN MA900 II eco was manufactured in 2016. It is a hydraulic injection moulding machine with a clamping force of 900kN and a shot volume of 153 cm3. Consider the opportunity to buy this HAITIAN MA900 II eco hydraulic injection moulding machine. Contact us for more information.

• Injection Capacity (PS): 139 g
• Plasticization Capacity: 13.3 g/s
• Heating power: 7. 85 kw
• Tie-bar spacing (hxv): 360 × 360 mm
• Die-height available: 150 – 380 mm
• Ejector number: 5
• Pump motor power: 11 kw
• Minimum mold size (l×w): 250 × 250 mm
• Required Installation Space: Should allow at least 1 m clearance around the machine for operation and maintenance
• Machine Foundation & Mat Diagram
• Foundation Type: Reinforced concrete foundation recommended.
• Load-bearing Capacity: Must support ≥ 3.5 t machine weight.
• Level Tolerance: Machine must be installed on a level foundation (≤ 0.2 mm/m slope).
• Vibration Damping: Use anti-vibration pads or steel plates under machine feet
• Cable & Electrical Requirements
• Pump Motor Power: 11 kW
• Heating Power: 7.85 kW
• Total Installed Power (approx.): ~19 kW
• Power Supply: 3-phase, typically 400V / 50Hz (check local spec).
• Circuit Breaker Recommendation: ≥ 40 A (depends on local standards).
Gtodox D I Uuspfx Aaceu
• Grounding: Reliable grounding required (≤ 4 Ω resistance).
• Cable Suspension Diagram: Machine must be leveled before connecting cables
• Cooling & Hydraulic Requirements
• Oil Tank Capacity: 190 L (use recommended hydraulic oil ISO VG46).
• Cooling Water Requirement:
• For Hydraulic Oil Cooler
• For Mold Cooling Circuits (4 × water passages provided)
• Water Quality: Clean, non-corrosive, filtered.
• Water Pressure: 0.2 – 0.4 MPa
• Environmental Conditions
• Ambient Temperature: 5 – 40 °C
• Relative Humidity: ≤ 90% (non-condensing)
• Installation Location: Indoor, vibration-free, dust-free environment

Dimensions
Machine Depth 4530 mm