Digipot V2.6 gas actuator for diesel – 1 piece

Holzleitner

Electronic throttle position sensor for diesel engines with adjustable settings for sensor wire breakage and short-circuit detection.
The throttle position sensor can be used with all diesel engines that have a target speed setting via a resistor, e.g., Fendt, Steyr, Valmet, etc. This throttle position sensor can also be used with models equipped with Hall sensors. The necessary limit values for sensor wire breakage or short-circuit MCU error detection can be adjusted on the back using two adjustment knobs.
Installation:
The throttle position sensor must be wired in parallel with the tractor's manual throttle control. A toggle switch (included) allows switching between speed adjustment via remote control or normal manual throttle.

Technical data:
Target value sensor resistance: 0-10 kOhm
Wire breakage resistance: 0-1.5 kOhm
Short-circuit resistance: 0-1.5 kOhm
Inputs: Speed +: 5-14 VDC
Speed -: 5-14 VDC

Installation kit consists of:
1 electronic throttle position sensor
1 toggle switch, radio-0-manual
1 cable harness (cable length approx. 0.75 m)
1 set of mounting hardware
1 installation diagram
Installation time:
Approx. 2-3 hours, depending on the tractor model
Ndodpo Adgagofx Ahboc
WARNING! ONLY SUITABLE FOR ENGINES WITH EMISSION STANDARDS BEFORE "TIER 4" (BEFORE 2019)! PLEASE INQUIRE FOR ENGINES WITH LATER EMISSION STANDARDS!

The listing was translated automatically. Translation errors are possible.