Flatbed + tarpaulin

Fliegl SDS 390 MegaRunner X traLong 15030

Additional information
Chassis, semi-trailer, transport company
Fine-grained steel welded construction, with preload for slight tension in the neck area, kingpin plate with interchangeable 2 kingpins
X-tra Long, with an internal length of 15030 mm
Outer frame slightly angled, new design with Load-Lock profile for attaching lashing straps
24-ton, 2-speed landing gear, single-side operation, with straight lower part, without thrust compensation
Note: Free support foot angle or free swivel radius to the rear approx. 1930 mm
Retractable ladder at the rear
Door lock on the side
2 chocks with holder
Aluminum side impact protection
Galvanized steel under-ride protection
Partial wheel arches in front of the 1st axle and behind each axle
Rear impact protection
Axles + Suspension
SAF disc brake axles
Axle/chassis laser-aligned to reduce tire wear and fuel consumption
Air suspension
Braking system
2-line compressed air braking system
Color-coded lines for easy servicing
Spring brake parking brake
2 non-interchangeable coupling heads at the front, without connecting line
EBS, electronic braking system with EBS socket at the front, without connecting cable
Caution: The semi-trailer may only be pulled by towing vehicles that guarantee the effectiveness of the ABS!
with lifting and lowering valve
Vehicle driving stability system
AAC Basic, automatic lift axle acting on the last axle, as an aid for maneuvering, up to 20 km/h, can be manually switched off
Axle load detection via EBS-Canbus signal, for display on the driver's cab, truck must be appropriately prepared, no truck installation (no calibrated scale)
Wheels & Tires
Ppsdji Riwuopfx Anpju
435/50R19.5, manufacturer's choice
Steel rims, factory silver
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the side
Yellow LED lighting on the side coupled with the turn signal, flashing
Side marker lights
2 white position lights at the front
2 white/red side marker lights at the rear
2 x 7-pole non-interchangeable sockets at the front, without connecting cable
Floor
Sieved plywood, approx. 30 mm thick, on longitudinal supports for high point load capacity for forklift axle load up to max. 7100 kg
Front wall / Corner posts at the front
2580 mm high, corner posts steel in full volume design, release mechanism for side tarpaulin on the front wall, crash blocker, at the bottom inside at approx. 140 mm height with steel impact protection
Center posts
3 pairs of sliding posts that can be moved along the entire length, with 4-fold
insert pockets & at the bottom with a long pocket.
3 pairs of post positions
Insert slats
5 rows of wooden slats
Rear wall / Corner posts at the rear
Corner posts at the rear steel up to the lower edge of the roof, attachment for tarpaulin with round tube
and tarpaulin tensioning ratchet
Rear portal doors, 2-wing with 2 internal swivel latch locks each
Tarpaulin
Tarpaulin, with welded-in horizontal and vertical straps
Tensioning closures made of stainless steel
Roof
Sliding roof, rear end lift that can be folded up, with roof that can be slid from back to front, L-roof beam for the automotive industry, interior width between the roof beams
approx. 2490 mm, tarpaulin color: white
Roof non-elastic, hardly any deflection of the roof beam during loading and unloading
EcoLift - liftable roof by approx. 380 mm, on both sides, with gas spring support,
3 driving positions at the front:
Interior height at the front set to approx. 3000 mm
Optimal rain gutter at the rear, at the top of the end ra

The listing was translated automatically. Translation errors are possible.