Used Haas St-30Y for sale (2)

Condition: ready for operation (used), Year of construction: 2022, spindle speed (max.): 3,400 rpm, travel distance X-axis: 239 mm, travel distance Y-axis: 51 mm, travel distance Z-axis: 826 mm, spindle motor power: 22,400 W, number of axes: 3, This 3-axis HAAS ST-30Y horizontal turning machine was manufactured in 2022. It features a 10-inch chuck, a maximum cutting diameter of 13.75 inches, and a cutting length of 32.5 inches. The machine includes a 12-station BMT-65 turret and live tooling speeds up to 4,000 rpm. Y-axis capabilities allow for off-center milling, drilling, and tapping. Consider the opportunity to buy this HAAS ST-30Y horizontal turning machine. Contact us for more information. • Chuck size: 10 in (≈254 mm) • Maximum bar capacity (through spindle): 3 in (≈76 mm) • Maximum part swing over front apron: 31.75 in (≈806 mm) • Maximum cutting diameter: 13.75 in (≈349 mm) using BMT65 turret • Maximum cutting length: 32.5 in (≈826 mm) • Rapid traverse: X 472 in/min (~12 m/min), Y 472 in/min (~12 m/min), Z 945 in/min (~24 m/min) • Spindle bore: 3.5 in (≈88.9 mm) • Maximum torque: 300 ft-lb @ 500 rpm (≈407 Nm) • Turret: 12-station BMT65 • Live tooling speed: up to 4,000 rpm • Y-axis capability: off-centre milling, drilling, and tapping • Coolant capacity: 55 gal (~208 L) • Air requirement: 4 scfm @ 100 psi (~113 L/min @ 6.9 bar) • Electrical: 3-phase, 195–260 V (region dependent) • Footprint: 151 in × 70 in × 79 in (without conveyor) Additional equipment Bcjdpfjx D Iixox Afcsw • Powered (live) tool holders • Various tool holders • Liners

Condition: ready for operation (used), Year of construction: 2020, spindle speed (max.): 3,400 rpm, number of axes: 4, This 4-axis HAAS ST-30Y horizontal turning machine was manufactured in 2020. It features C+Y-axis capability, a 3,400 rpm A2-6 spindle, and a 12-station BMT65 turret. The machine is equipped with an automatic tool presetter, bent-type chip conveyor, and programmable tailstock. Bodpfxoyh Hw Io Afcscw In 2021, a driven tool error occurred and the angular drive was replaced. After relocation, a geometric recalibration was carried out in 2022. Currently, there is an issue with internal bore accuracy: the machined inner hole appears slightly stepped. It may require main spindle centerline adjustment; however, a more significant spindle alignment issue cannot be fully excluded. The machine can be inspected under power and test cuts are possible upon request. Contact us for further details. • Running hours: 556 h • C+Y-axis • 3,400 rpm A2-6 spindle • 12-station BMT65 turret • Programmable Tailstock Additional equipment • Bent-Type Chip Conveyor • Oil skimmer • Exhaust system • Automatic Tool Presetter (ATP) • WIFI camera • Remote Jog Handle